8
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
8 - 67
[E030] Power-ON jam
Other Check if there is any paper clinging to the transfer belt or
entering under the receiving tray. Remove it if there is.
Use the paper within the specification if the thin paper being
used is out of specification.
Replace parts Remarks
Paper clinging detection sensor
Registration motor
PFC board
LGC board
Rollers
Classification Error item
Other paper jam The paper is remaining on the paper transport path when
power is turned ON.
Check item Measures
Transport path Open the cover, and then remove paper if there is any paper
on the transport path.
Sensor Sensor check (Refer to the table below)
Connector check
Harness check
PFC board Connector check
(CN500, CN505, CN506, CN509, CN511, CN512, CN513,
CN515)
Harness check
Board check
Replace parts Remarks
Sensor in the jamming area Refer to the table below
PFC board
ADU board
Jamming area Cover Sensor Test Mode/Input check
Paper path section Duplexing unit Registration sensor 03-[ALL]OFF/[4]/[B]
03-[COPY]ON/[5]/[H]
Transfer belt paper clinging
detection sensor
03-[ALL]OFF/[9]/[C]
2nd transfer side paper
clinging detection sensor
03-[ALL]OFF/[9]/[D]
1st drawer transport sensor 03-[SCAN]ON/[1]/[D]
Fuser Duplexing unit Fuser transport sensor 03-[ALL]OFF/[2]/[C]
03-[COPY]ON/[5]/[F]
Reverse path sensor 03-[ALL]OFF/[1]/[C]
03-[SCAN]ON/[3]/[E]
Check item Measures
To Next Page
Loading...
