e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
8 - 68
[E061] Incorrect paper size setting for 1st drawer
[E062] Incorrect paper size setting for 2nd drawer
[E063] Incorrect paper size setting for 3rd drawer
[E064] Incorrect paper size setting for 4th drawer
[E065] Incorrect paper size setting for bypass tray
ADU Duplexing unit
Cover
Duplexing unit path exit sensor 03-[SCAN]ON/[3]/[G]
Duplexing unit path entrance
sensor
03-[SCAN]ON/[3]/[H]
Bypass unit Duplexing unit Bypass feed sensor 03-[SCAN]ON/[3]/[A]
Feeding area
(equipment)
Paper feed
cover
4th drawer transport sensor 03-[SCAN]ON/[1]/[A]
3rd drawer/tandem LCF
transport sensor
03-[SCAN]ON/[1]/[B]
2nd drawer transport sensor 03-[SCAN]ON/[1]/[C]
LCF LCF side cover Option LCF feed sensor 03-[SCAN]ON/[5]/[E]
Bridge unit Front cover Bridge unit path exit sensor 03-[ALL]OFF/[1]/[A]
03-[SCAN]ON/[3]/[C]
Bridge unit path entrance
sensor
03-[ALL]OFF/[1]/[B]
03-[SCAN]ON/[3]/[D]
Reverse sensor 03-[SCAN]ON/[3]/[F]
Reverse section stationary jam
detection sensor
03-[SCAN]ON/[4]/[A]
Upper exit section - Upper paper exit sensor 03-[ALL]OFF/[1]/[E]
03-[COPY]ON/[7]/[A]
Lower exit section - Lower paper exit sensor 03-[ALL]OFF/[4]/[C]
03-[COPY]ON/[5]/[G]
Reverse section Reverse path
cover
Reverse section paper
transport detection sensor
03-[COPY]ON/[8]/[F]
Finisher Finisher door Sensors in the finisher -
Classification Error item
Other paper jam The size of paper in the 1st drawer differs from size setting of
the equipment.(E061)
The size of paper in the 2nd drawer differs from size setting of
the equipment.(E062)
The size of paper in the 3rd drawer differs from size setting of
the equipment.(E063)
The size of paper in the 4th drawer differs from size setting of
the equipment.(E064)
The size of paper in the bypass tray differs from size setting
of the equipment.(E065)
Check item Measures
Setting If any paper remains in the equipment or drawer, remove it.
Match the paper size of the drawer setting and the one in the
drawer.
Paper size detection is performed at the first sheet of paper
when the drawer is opened or closed, or when the power of
the equipment is turned ON.
Jamming area Cover Sensor Test Mode/Input check
To Next Page
Loading...
