8
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
8 - 239
[2E11] Insufficient memory capacity for USB storage
[2E12] Message reception error in USB storage
[2E13] Message transmission error in USB storage
[2E14] Invalid parameter for USB storage
[2E15] Exceeding maximum file capacity
Replace parts Remarks
Classification Error item
File sharing related error Memory in the USB folder is not sufficient.
Check item Measures
Setting If there is a job in progress, perform the job in error again
after the job in progress is finished. If the error still occurs,
turn the power OFF and then back ON, and then perform the
job in error again.
Replace parts Remarks
Classification Error item
File sharing related error Job status is invalid.
Check item Measures
Setting Turn the power OFF and then back ON. Perform the job in
error again.
Replace parts Remarks
Classification Error item
File sharing related error The specified parameter is invalid.
Check item Measures
Setting If a template is being used, recreate the template. If the error
still occurs, turn the power OFF and then back ON. Perform
the job in error again.
Replace parts Remarks
Classification Error item
File sharing related error There are too many files in the folder.
To Next Page
Loading...
