Tips and Tricks
• For the majority of HVAC applications the Quick Menu, Quick Set-up and Function Set-up provides the
simplest and quickest access to all the typical parameters required
• Whenever possible, performing an AMA, will ensure best shaft performance
•
Contrast of the display can be adjusted by pressing [Status] and [
▲
] for darker display or by pressing
[Status] and [
▼
] for brighter display
• Under [Quick Menu] and [Changes Made] all parameters that have been changed from factory settings
are displayed
• Press and hold [Main Menu] key for 3 seconds for access to any parameter
• For service purposes it is recommended to copy all parameters to the keypad, see par. 0-50
LCP Copy
for further information
Quick Transfer of Parameter Settings when using keypad
Once the set-up of a frequency converter is complete, it is recommended to store (backup) the parameter settings
in the keypad or on a PC via TDU Set-up Software Tool.
Stop the motor before performing any of these operations otherwise unexpected operation can occur. Disconnect all
electric power, including remote disconnects before servicing. Follow proper lockout/tagout procedures to ensure the
power can not be inadvertently energized.
Failure to follow recommendations could result in death or serious injury..
Data storage in keypad:
1. Go to par. 0-50
LCP Copy
2. Press the [OK] key
3. Select “All to keypad”
4. Press the [OK] key
All parameter settings are now stored in the GLCP indicated by the progress bar. When 100% is reached, press
[OK].
The GLCP can now be connected to another frequency converter and the parameter settings copied to this
frequency converter.
Data transfer from keypad to Frequency converter:
1. Go to par. 0-50
LCP Copy
2. Press the [OK] key
3. Select “All from keypad”
4. Press the [OK] key
The parameter settings stored in the GLCP are now transferred to the frequency converter indicated by the
progress bar. When 100% is reached, press [OK].
How to Operate the Frequency Converter
BAS-SVX19C-EN 5-11
To Next Page
Loading...
