Configure the separations module
July 29, 2013, 715003794 Rev. B 95
9. Press the OK screen key.
Set report options
Use the Report Options dialog box to define information sent to the printer or
integrator. (Before you print a report, select the printer in the Printer section
of the Configuration screen. You select the destination of the report in the
print dialog box that appears when you press the Print screen key.)
To define the information sent to a printer or integrator:
1. Press the Reports screen key to display the Report Options dialog box.
2. In the list that appears, select the report’s destination.
Rule: If the RS-232 port is configured for remote control, or you
previously set the printer selection to None, you can select only Disable
Reporting.
3. Select any option, press any numeric key (to enable the option), and then
press Enter.
Tip: These are the options and their functions:
• Gradient table – Generates the gradient table described in the table
on page 156.
• I/O event table – Generates the I/O table described in the table on
page 165.
• Detector table – Generates the detector table described in the table
on page 174.
• Event overview – Generates an overview of all merged tables
• Misc. parameters – Generates a list of all parameters not included
in tables
• System config – Generates a list of the instrument configuration
parameters
• Per-inject data – Generates a list of the minimum, maximum, and
average values for temperature and pressure, the time and date of
each injection, the bar code number, and so on
• Alarms – Generates a list of the error conditions that occurred
during each injection
4. Press the OK screen key to exit the Report Options dialog box.
To Next Page
Loading...
