Waters Alliance e2695 - Page 96

3 Prepare the e2695 Separations Module for Operation
96 July 29, 2013, 715003794 Rev. B
5. Press Exit to return to the Main screen.
The following figure is an example of a report made with all options
selected.
Sample report:
REPORT: Alliance e2695 Separations Module
SERIAL NUMBER: F01SM7885M
PRINTED: 03/17/08 08:26:40am
USER: User
CONFIGURATION: Syringe (250 uL), Loop (100 uL)
SEPARATION METHOD: Default
(1) MOBILE PHASE
Low pressure alarm: Disable
High pressure alarm: Disable
Bubble detect alarm: Alert user
Flow Ramp: 2.00 min (5.0 mL/min/min)
Degasser Mode: On
Degasser fail alarm: Alert user
Pump sealwash period: 1.00
Preferred stroke volume: 130 uL
Gradient: (min) (mL/min) %A %B %C %D Curve
1. INIT 0.000 100.0 0.0 0.0 0.0
(2) SAMPLE
Sample temperature: 4C
Sample temp alarm:Log quietly +/- 5C
Syringe draw (rate): Normal (2.50 uL/sec)
(depth): 3 mm from bottom of vial
(3) AUTOSAMPLER
Pre-column volume: 0.0 uL
Post-run delay: 0.00 min
Compression check alarm: Disable
(4) COLUMN
Column temperature: 35C
Column temp alarm:Log quietly +/- 5C
(5) I/O
Chart output: System pressure
Table: (min)Event TypeAction Param
1. 0.00Switch 1On
(6) DETECTORS
2487-1:Enabled
2487-2:Disabled
2410:Enabled
2410 Sensitivity:1
2410 Cell temperature:30.0C
2410 External temp 1: 25.0C
2410 External temp 2: 25.0C
2410 Filter: 3.0 sec
2410 Autozero on inject: Yes