Service Manual FB 7100 Brewer System
January, 2005 5B - 15
B.3.9 Removing the actuator
Preparation Before removing the actuator:
• Switch off the main switch, disconnect the power supply, and close the
water tap.
• Remove the brewer, see this section, page 5B-4.
• Remove the brewer cylinder, the filter plate holder and the scraper, see
this section, page 5B-7.
• Remove the brewer housing, see this section, page 5B-8.
• Disassemble the tie rods with the filter plate support, see this section,
page 5B-9.
• Disassemble the ingredient motor, see this section, page 5B-11.
• Disassembling the scraper arms, see this section, page 5B-13.
The actuator of the brewer is provided with a heavy spring under tension.
Always turn the top and bottom of brewer away from any person before
removing the scraper, as a defective actuator could expand suddenly.
There is an increased risk of injuries.
Removal Follow these steps to remove the actuator from the brewer unit:
Step Action Illustration
1 Unplug the cable of the
brewer at end switch
2 Remove the four screws (1)
from the base of the brewer
1
To Next Page
Loading...
