Service Manual FB 7100 Brewer System
5B - 4 January, 2005
B.3.2 Dismounting the brewer unit
When repairing the brewer unit, these safety rules must be observed:
• Beware of sharp edges
• Beware of spring loaded actuator, if defective
Tools needed: Clamp (if actuator is taken out of the brewer unit)
Preparation Follow these steps to prepare the brewer unit for removal:
Warning If it was not possible to move the brewer into transport position, only
touch the brewer on its outside. Do not reach underneath the brewer
cylinder, as there is a risk of injuries if the actuator is defective.
Continued ...
Step Action
1 Remove the coffee canister.
2 Detach the filter roll bracket from its location peg. (if applied)
3 Pull off coffee outlet hose
4 Place a piece of eg. corrugated paper on the filter plate and bring the
brewer cylinder into transport position.
Warning! Keep hands and loose objects away from the brewer!
Warning! If the cylinder is not closed you must be careful when
proceeding with the removal. If nut, plunger holder or spindle are
defective the actuator spring load may be released causing danger of
injury!
5 Switch off the main switch, disconnect the power supply, and close the
water tap.
6 Pull of the hot water hose.
7 Remove the water inlet elbow tube from the brewer, and push it to the
side.
To Next Page
Loading...
