Service Manual FB 7100 Dosing System
January, 2005 5C - 7
When reinserting the whipper wheel make sure to turn it correctly con-
cidering that the insertion hole and the connecting pin are D-shaped.
C.2.6 Removing an instant ingredient motor
Preparation Before removing an instant ingredient motor
• Open the door
• Switch off the main switch.
• Remove instant ingredient canisters.
• Remove tray under canisters.
• Remove cover plate for instant module, see this section, page 5C-3.
Remember to close the outlet spouts of instant ingredient canisters before
removing canisters.
Removal Follow these steps to remove an instant ingredient motor:
Installation Installation is done in reverse order.
Remember to open the outlet spouts of instant ingredient canisters after re-
installation.
Step Action Illustration
1 Pull out the instant ingredient
motor in question from mounting
bracket on back wall of cabinet.
2 Disconnect the electrical connections.
To Next Page
Loading...
