Service Manual FB 7100 Replacing the SPC circuit board
5K - 14 January, 2005
Installation Follow these steps to install the SPC circuit board:
4 Remove the PIC micro
controller (4) from the SPC
circuit board (5) using a
special tool (6).
Step Action
4
5
6
Step Action
1 Place the insulating foil (1) on
the mouting plate (2).
2 Place the SPC circuit board
(3) on the insulating foil and
attach the SPC circuit board
to the mounting plate using 15
new plast push-in rivets (4).
3 Reinsert and fasten the
earting screw (5) to the SPC
circuit board.
4 Place the PIC micro controller
(6) on the new SPC circuit
board.
Ensure correct
installation of PIC
miro controller,
see
"Installation of PIC
micro controller"
below.
1
2
3
4
5
6
6
To Next Page
Loading...
