Service Manual FB 7100 Event recording and troubleshooting
3 - 4 January, 2005
3.1.1 Event messages in connection with Diagnostic/Test
Diagnostic/Test
messages
Event messages that may appear during the testing of any of the machine’s
functions are explained in chapter 4 Programming, section 4.3.11
Diagnostic/Test menu, page 4-79 as these messages are closely connected
to the testing procedures.
3.1.2 Event messages in event book and credit display
Basetray full This message indicates that the drip tray is full or that another problem
related to the drip tray has caused the machine to stop operating.
Door closed
(log book only)
The purpose of the “Door closed” message is to record the time and date
of door closings. However, the message is also being given when power is
returned to the machine.
Door open
(log book only)
This message is either a status indication similar to the message above
“Door closed” or an indication of a problem with the door.
Possible cause Remedy
Drip tray full Switch machine off, empty drip tray and
dry sensors.
See chap. 5C, page 5C-6
Drip tray sensors soiled Clean and wipe dry sensors.
See chap. 5C, page 5C-6
Drip tray sensors defective Check, replace if necessary.
See chap. 5C, page 5C-4
Harness for drip tray sensors defective Check, replace if necessary.
See chap. 5C, page 5C-4
Possible cause Remedy
Door not closed properly Close door properly.
Door switch defective Check, replace if necessary.
See.chap. 5G, page 5G-11 and 5.chap.
5G, page 5G-12.
Door harness defective Check, replace if necessary.
To Next Page
Loading...
