Maintenance
11-14 Xerox 4112/4127 Copier/Printer
User Guide
1. Wipe the exterior with a soft cloth moistened with water. If dirt is difficult to remove, try
gently wiping with a soft cloth moistened with a small amount of neutral detergent.
2. Wipe off any excess water from the exterior with a soft cloth.
Cleaning the Document Cover and Document Glass
Cleaning the document cover and glass on a regular basis is important to providing the best
image quality possible on your printed or copy output. If the document cover and document
glass are dirty, spots may appear on copies and the machine may not properly detect
document sizes.
Note
If you receive this message, “The Scanner may be dirty. See User Guide or label instructions on
the Document Feeder to wipe the scanning glass,” perform the cleaning procedure for the
document cover and document glass.
It is recommended that you clean all components of the Document Cover and Document Glass
at the same time. These components consist of the document cover, the document (platen)
glass, and the second-side scanning lens assembly.
To clean all three of these components, use the following procedure.
Cleaning the document cover
Note
The document cover is the flat, white surface on the underside of the DADF that holds the
document in place on the document glass.
WARNING
Before you start to clean the machine, be sure to switch off the power and unplug the machine.
Cleaning the machine without switching off the power may cause an electric shock.
CAUTION
Do not use benzene, paint thinner, other volatile liquids, or spray insect repellent on the
machine as doing so may discolor, deform, or crack covers.
CAUTION
Cleaning the machine with an excessive amount of water may cause the machine to
malfunction and/or damage documents during copying.
To Next Page
Loading...
Need help?
General
