Xerox 4112 User Manual

Addendum
Xerox 4112/4127 Copier/Printer 14-27
User Guide
Hints and Tips for using the HCS
1. Check the paper in the Stack Tray for curl.
• No, curl is not present.
• If the output acceptable and meets customer satisfaction, you are finished.
• If the output is not acceptable, call for service.
• Yes, curl is present: continue to the next step.
2. Adjust the paper curl by using the Decurler Controls on the top of the Interface Module;
refer to page 18 for more information on adjusting paper curl.
3. If the output has not improved, adjust the paper curl again.
4. If the output still has not improved, call the Customer Support Center.
Fault Codes
Fault code Possible cause Recommended solution
049 100
049 101
049 102
049 104
049 106
049 108
049 113
049 114
049 115
049 116
049 117
049 119
049 121
049 900
049 901
049 902
049 903
049 905
049 907
049 908
Paper jam
A jam occurred during
feeding
A jam notification is
displayed on the UI
Open the front door.
Carefully remove all sheets and paper scraps from jam
clearance areas.
Close the front door.
Verify the paper used is within the approved paper
specifications.
049 210
049 211
Front door sensor
problem
Power off, then power on
049 212
049 213
Stacker tray did not raise
or lower properly
Power off, then power on
049 214
049 215
049 216
049 217
049 218
Sensor problem/failure Power off, then power on
049 219 Front door software
failure
The front door switch is detected as “open,” but the front
door is actually closed (locked). Power off, then power on.
049 220
049 221
Stacker upper limit failure
Stacker lower limit failure
Power off, then power on

Xerox 4112 Specifications

General

Brand	Xerox
Model	4112
Category	All in One Printer
Language	English