Xerox 4112/4127 Copier/Printer 12-1
User Guide
12
Problem Solving
Tip
The User Interface (UI) screens shown in this guide may or may not reflect the screens
displayed on your system. The UI screens vary from system to system and from marketplace to
marketplace. Therefore, the UI screens in this guide are a representation of the type of screens
that may be seen on your particular system.
Initial Troubleshooting Procedures
To use the following machine troubleshooting procedures:
1. Begin by reading the first Symptom at the left side of the page.
2. If the description of the symptom is False (NO), move downward to the next symptom.
Continue down through the Symptoms until you find the symptom that describes the
problem.
3. Refer to the Causes and Actions to the right of the correct symptom. Perform the
suggested actions until the problem is solved.
Symptoms Causes and Actions
Power is not switched
On.
Yes Cause Is the power switch on the machine turned off?
If NO, go to next symptom. Action
Turn the power switch o n.
Refer to Power on/off on page 1-14.
If problem is not solved, go to next Cause/Action.
Cause Is the power cord plugged into the power outlet?
Action
Turn the power switch off and then firmly plug in the
power cord.
Then turn the power switch on.
Refer to Power on/off on page 1-14.
If problem is not solved, go to next Cause/Action.
Cause
Is the power disconnected from the machine or the rear of
the rack?
Action
Turn the power switch off and then firmly plug in the
power cord.
Then turn the power switch on.
Refer to Power on/off on page 1-14.
To Next Page
Loading...
Need help?
General
