Addendum
Xerox 4112/4127 Copier/Printer 14-23
User Guide
3. Up to 500 sheets are transported to the Top Tray:
• When sheets are purged after a paper jam.
• When the Sample Set button is selected.
• When selected as an Output Location.Labels must be sent to the Top Tray.
4. Only used when a second stacking/finishing device is installed. This path transports collated
sets through the HCS to a connected finishing device or to another HCS.
Control Panel
1. Sample indicator: This indicator blinks until a proof set is delivered to the Top Tray.
2. Sample button: Press this button to have the HCS deliver the next collated set to the top
tray.
3. Unload button: Press once to lower the Stacker Tray and unlock the front door.
4. Unload indicator: This indicator lights when the Stacker Tray has reached the down
position and the front door can be opened.
5. Top Tray jam area: Blinks when there is a jam in the top tray area (E7).
6. Exit jam area: Blinks where there is a jam in the exit area (E8).
7. Stacker Entrance jam area: Blinks when there is a jam in the Stacker Entrance area (E1, E2,
or E3).
8. Stacker Transport jam area: Blinks when there is a jam in the Stacker Transport area (E4,
E5, or E6).
HCS Trays
Top Tray
The Top Tray offers the following:
• Copies/prints are aligned easily without folds or winkles in the output.
• To enable easier pick-up of the output copies/prints, the HCS can be stopped by selecting
the Stop button on the machine's UI.
2
1
5
3
4
6
8
7
To Next Page
Loading...
Need help?
General
