Xerox 8830 - Problem Solving - System Issues (continued); System Initialization Failure (Clock Display) (continued)

REP 8.3 Buckle Switch
Parts List on PL 8.4
WARNING
Switch off the Main Power Switch. Disconnect the
Power Cord.
Removal
1. Latch the Xerographic Module at the Service
Position (REP 9.2).
2. Remove the Media Transport Assembly (REP
8.1).
3. Remove the Fabric Guide (REP 8.9).
4. Remove the Pressure Plates (REP 8.5).
5. (Figure 1): Remove the Buckle Switch.
a. Remove the screw.
b. Carefully pull the Buckle Switch Assembly
until the connector can be disconnected.
c. Disconnect the connector.
. d. Remove the Buckle Switch from the bracket.
Screw
Buckle Switch
R3026K
Figure 1. Removing the Buckle Switch
8830
1/98
4-21
REP 8.3