REP 7.4 Roll Feed Drive Rolls
Parts List on PL 7.1
WARNING
Switch off the Main Power Switch.
Disconnect the Power Cord.
NOTE: All three Roll Feed Drive Roll assemblies
are removed the same way.
Removal
1. Remove the appropriate Media Supply
Drawer (REP 7.1).
2. Remove the Feed Clutch (REP 7.5).
3. Remove the Toner Waste Container.
4. (Figure 1): Remove the Roll Feed Drive
Rolls.
Remove the
E-ring
Remove the
bearing
Remove the
E-ring
5
Remove the
Drive Rolls
Figure 1. Removing the Roll Feed Drive Rolls
REP 7.4
1/98
4-8
8830
R01859
To Next Page
Loading...
Need help?
General
