REP 9.8 Scorotron Pin Kit
Parts List on PL 9.3
NOTE: These are the instructions to install the
Scorotron Pin Kit. The kit contains the following
items:
• Pin Array
• Torsion Spring (2)
• Container
WARNING
Switch off the Main Power Switch. Disconnect the
Power Cord.
Removal
1. Loosen the screws and open the Rear Cover.
2. Raise and latch the Top Cover.
3. Rotate the Image Module to the Service Position.
4. (Figure 1): Remove the Charge Scorotron
Assembly from the Printer and place it on a flat
surface.
2
Rotate the screws until they
are free of the mounting
blocks on the Image Module
Figure 1. Removing the Charge Scorotron Assembly
REP 9.8
1/98
4-64
8830
1
To Next Page
Loading...
