5. (Figure 3): Complete the installation of the
remaining two Blade Retainers, positioning them,
one at a time, to the left of the first one.
6. Replace the Left-hand Seal.
a. Insert the red stripe end of the Left-hand
Seal underneath the folded Photoreceptor
Seal.
b. Install the seal fuzzy side up.
c. Ensure that the seal is flush against the
Xerographic Module Frame.
7. Perform GP4 Drum Cleaning Enhancement
procedure.
Xerographic
Module Frame
R3013K
Figure 3. Installing the Cleaner Blade Kit
REP 9.4
1/98
4-52
8830
To Next Page
Loading...
