Section 6. - General Procedures
This section contains Diagnostic Procedures,
Installation Procedures, and General
Information, which includes Product
Specifications for the 8830.
Section 7. - Wiring Data
This section contains Plug/ Jack Location index,
Plug/ Jack Location Drawings, and the BSDs.
Section 6. - Accessories
This section contains service information about
accessories for the 8830 Printer. As
accessories are added to the customer
configuration, they will be added to this section.
How to Use This Manual
The Service Call Procedures will direct you to
the appropriate Section of the Service Manual.
You should begin the service call with the Initial
Actions/ System Checks Procedure. From
there, you will be referred to either Section 2,
Status Indicator RAPs, Section 3, Image Quality
RAPs, Section 7 BSDs or Section 8,
Accessories.
If you are sent to Section 3, compare the image
defect to the print quality definitions. Once you
have determined the definition that best
describes the copy defect, go to the section
contents. The section contents will direct you to
an image quality RAP. The RAP has a list of
probable causes and corrective actions. From
these RAPs you may be referred to other
sections of the manual to make checks,
adjustments, or to replace the parts.
When you have made a repair, always go to the
Call Flow Diagram to finish the call.
1/98
8830 vii Introduction
To Next Page
Loading...
Need help?
General
