[Q]
Fasten the battery positive
(+)
lead with a bat-
tery box clam
p.
If]
The carburetor heater relay should not touch
the wire harness.
[Q]
Fasten
the wire harness with a plastic locking tie.
[ill
Place
the end
of
the plastic locking tie
as
shown.
[§]
From the engine.
[I]
Pass
the starter
motor
lead over the battery
negative (-) lead.
[Q]
Fasten the pickup coil lead,
A.C.
magneto lead,
neutral switch lead and starter motor lead with
CABLE
ROUTING
I
SPEC
I
U-I
a plastic locking tie.
[2]
Fasten the battery negative (-) lead, starter
motor lead and wire harness with a plastic
locking tie.
IWl
Fasten the wire harness with a clamp.
00
Fasten the battery negative (-) lead and tail!
brake light lead with a clamp.
[YJ
Pass
the wire harness between the frame and
battery box.
[%]
Fasten the starter cable with a plastic locking
tie.
a-a
A-A
-9
-
To Next Page
Loading...
