Yealink T21PE2 - Page 175

Phone Customization
169
Values 1-Network CallLog (only appear when "bw.enable=1" and "bw.xsi.call_log.enable=1")
Default 0
Web UI Dsskey->Programmable Key->Line
Parameter
programablekey.X.line
[1]
<y0000000000xx>.cfg
Description
It configures the desired line to apply the programmable key feature.
Note: It is not applicable to T19(P) E2 IP phones.
Permitted
Values
T48G/T48S/T54S/T46G/T46S/T29G: 1-16;
T52S/T42S/T42G: 1-12;
T41S/T41P/T27G: 1-6;
T40P/T40G/T23P/T23G: 1-3;
T21(P) E2: 1-2;
CP920: 1, 101, 102.
1-Line 1
2-Line 2
…
16-Line 16
101-PSTN1
102-PSTN2
Default 1
Web UI Dsskey>Programmable Key->Line
Parameter
programablekey.X.value
[1]
<y0000000000xx>.cfg
Description
It configures the value for some programmable key features.
For example, when you assign the Speed Dial to the programmable key, this parameter is used to specify
the contact number you want to dial out. It is also used to specify the contact number with the DTMF
sequence. The contact number and DTMF sequence are separated by commas.
Note: You need to configure this parameter when “programablekey.X.type” is set to 2, 9, 13, 14, 23, 24, 27,
40 or 73.
Permitted
Values
String within 99 characters
Default Blank
Web UI Dsskey->Programmable Key->Value
Parameter
programablekey.X.label
[1]
(X=1-4)
<y0000000000xx>.cfg
Description
It configures the label displayed on the phone screen for a specific programmable key.
This is an optional configuration.
Permitted
String within 99 characters