Yealink T21PE2 - Page 273

Call Features
267
Description
It enables or disables the digit map feature for the IP phone.
Note: The value configured by the parameter “account.X.dialplan.digitmap.enable” takes precedence
over that configured by this parameter.
Permitted
Values
0-Disabled
1-Enabled
Default 0
Parameter dialplan.digitmap.string <y0000000000xx>.cfg
Description
It configures the digit map pattern used for the dial plan.
Example:
dialplan.digitmap.string = <[2-9]x:86>3.T|0x.!|1xxx
Note: The string must be compatible with the digit map feature of MGCP described in 2.1.5 of RFC 3435. It
works only if “dialplan.digitmap.enable” or “account.X.dialplan.digitmap.enable” is set to 1 (Enabled). The
value configured by the parameter “account.X.dialplan.digitmap.string” takes precedence over that con-
figured by this parameter.
Permitted
Values
String within 2048 characters
Default [2-9]11 | 0T | 011xxx.T | [0-1][2-9]xx xxxxxxx | [2-9]xx xxxxxxx | [2-9]xxxT | **x.T | +x.T| 00x.T
Parameter dialplan.digitmap.interdigit_long_timer <y0000000000xx>.cfg
Description
It configures the time (in seconds) for the IP phone to wait before dialing an entered number if it matches
part of any string of the digit map.
If it is set to 0, the IP phone will not dial the entered number if only a partial match exists.
The value of this parameter should be greater than that configured by the parameter “dial-
plan.digitmap.interdigit_short_timer”.
For example:
dialplan.digitmap.string = 1xxT|xxxxx<T1>
dialplan.digitmap.interdigit_long_timer = 10
dialplan.digitmap.interdigit_short_timer = 5
When you enter 1, it matches part of two-digit maps, the IP phone tries to wait 10 seconds and then dials
out 1 if no numbers entered;
When you enter 15, it also matches part of two-digit maps, the IP phone tries to wait 10 seconds and then
dials out 15 if no numbers entered;
When you enter 153, it also matches part of two-digit maps, the IP phone tries to wait 10 seconds. But
after waiting for 5 seconds, it completely matches the first digit map and then immediately dials out 153.
Note: It works only if “dialplan.digitmap.enable” or “account.X.dialplan.digitmap.enable” is set to 1
(Enabled). The value configured by the parameter “account.X.dialplan.digitmap.interdigit_long_timer”
takes precedence over that configured by this parameter.
Permitted
Values
Integer from 0 to 255
Default 10