Yealink T21PE2 - Page 274

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
268
Parameter dialplan.digitmap.interdigit_short_timer <y0000000000xx>.cfg
Description
It configures the timeout interval (in seconds) for any string of digit map.
The IP phone will wait this many seconds before matching the entered digits to the dial plan and placing
the call.
Note: It works only if “dialplan.digitmap.enable” or “account.X.dialplan.digitmap.enable” is set to 1
(Enabled). The value configured by the parameter “account.X.dialplan.digitmap.interdigit_short_timer”
takes precedence over that configured by this parameter.
Permitted
Values
Single configuration (configure a specific value for the timer letter “T” for all strings with “T” of the digit
map)
Example:
dialplan.digitmap.interdigit_short_timer = 5
If “dialplan.digitmap.string” is set to <[2-9]x:86>3.T|0T, the IP phone will wait 5 seconds before matching
the entered digits to this dial plan and placing the call.
Distribution configuration (configure a string of positive integers separated by “|” for each string of the
digit map in the corresponding position)
If there are more digit maps than timeout values, the last timeout is applied to the extra digit map. If there
are more timeout values than digit maps, the extra timeout values are ignored.
Example:
dialplan.digitmap.interdigit_short_timer = 4|5|3|6|2|1
If “dialplan.digitmap.string” is set to <[2-9]x:86>3.T|2T|1xxT|0x.!|[2-9]11T, 4 is applied to the “<[2-
9]x:86>3.T” digit map, 5 is applied to “2T” digit map, 3 is applied to “1xxT” digit map, 6 is applied to “0x.!”
digit map, 2 is applied to the “[2-9]11T” digit map, the last digit 1 is ignored.
Default 3
Parameter dialplan.digitmap.no_match_action <y0000000000xx>.cfg
Description
It configures the behavior when an impossible digit map match occurs.
Note: It works only if “dialplan.digitmap.enable” or “account.X.dialplan.digitmap.enable” is set to 1
(Enabled). The value configured by the parameter “account.X.dialplan.digitmap.no_match_action” takes
precedence over that configured by this parameter.
Permitted
Values
0-prevent users from entering a number and immediately dial out the entered numbers
1-the dialing will fail and the phone screen will prompt “Forbidden Number”
2-allow users to accumulate digits and dispatch call manually with the send key or automatically dial out
the entered number after a certain period of time configured by the parameter “dial-
plan.digitmap.interdigit_long_timer”
Default 0
Parameter dialplan.digitmap.active.on_hook_dialing <y0000000000xx>.cfg
Description
It enables or disables the entered numbers to match the predefined string of the digit map in real time. It
is only applicable to the on-hook dialing.
Note: It works only if “dialplan.digitmap.enable” or “account.X.dialplan.digitmap.enable” is set to 1
(Enabled). The value configured by the parameter “account.X.dialplan.digitmap.active.on_hook_dialing”
takes precedence over that configured by this parameter.