Yealink T21PE2 - Page 316

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
310
Note: It works only if “features.fwd.allow” is set to 1 (Enabled) and the value of the parameter “fea-
tures.fwd_mode” is set to 0 (Phone) (except T19(P) E2/CP920 IP phones).
Permitted
Values
String within 32 characters
Default Blank
Web UI Features->Forward&DND->Forward->Always Forward->Target
Phone UI Menu->Features->Call Forward->Always Forward->Forward to
Parameter forward.always.on_code <y0000000000xx>.cfg
Description
It configures the always forward on code to activate the server-side always forward feature.
The IP phone will send the always forward on code and the pre-configured destination number (con-
figured by the parameter “forward.always.target”) to the server when you activate always forward feature
on a phone basis.
Note: It works only if “features.fwd.allow” is set to 1 (Enabled) and the value of the parameter “fea-
tures.fwd_mode” is set to 0 (Phone) (except T19(P) E2/CP920 IP phones).
Permitted
Values
String within 32 characters
Default Blank
Web UI Features->Forward&DND->Forward->Always Forward->On Code
Phone UI Menu->Features->Call Forward->Always Forward->On Code
Parameter forward.always.off_code <y0000000000xx>.cfg
Description
It configures the always forward off code to deactivate the server-side always forward feature.
The IP phone will send the always forward off code to the server when you deactivate always forward fea-
ture on a phone basis.
Note: It works only if “features.fwd.allow” is set to 1 (Enabled) and the value of the parameter “fea-
tures.fwd_mode” is set to 0 (Phone) (except T19(P) E2/CP920 IP phones).
Permitted
Values
String within 32 characters
Default Blank
Web UI Features->Forward&DND->Forward->Always Forward->Off Code
Phone UI Menu->Features->Call Forward->Always Forward->Off Code
Parameter forward.busy.enable <y0000000000xx>.cfg
Description
It triggers the busy forward feature to on or off on a phone basis.
Note: It works only if “features.fwd.allow” is set to 1 (Enabled) and the value of the parameter “fea-
tures.fwd_mode” is set to 0 (Phone) (except T19(P) E2/CP920 IP phones).
Permitted
Values
0-Off
1-On, incoming calls are forwarded to the destination number (configured by the parameter “for-
ward.busy.target”) when the callee is busy.
Default 0