Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
316
Description
It triggers no answer forward feature to on or off.
Note: It works only if “features.fwd.allow” is set to 1 (Enabled) and “features.fwd_mode” is set to 1 (Cus-
tom). It is not applicable to T19(P) E2/CP920 IP phones. DND activated on the specific account deactivates
the local No Answer Forward settings.
Permitted
Values
0-Off
1-On, incoming calls to the account X are forwarded to the destination number (configured by the para-
meter “account.X.timeout_fwd.target”) after a period of ring time.
Default 0
Web UI Features->Forward&DND->Forward->AccountX->No Answer Forward->On/Off
Phone UI Menu->Features->Call Forward->AccountX->No Answer Forward->No Answer Forward
Parameter
account.X.timeout_fwd.target
[1]
<MAC>.cfg
Description
It configures the destination number of the no answer forward.
Note: It works only if “features.fwd.allow” is set to 1 (Enabled) and “features.fwd_mode” is set to 1 (Cus-
tom). It is not applicable to T19(P) E2/CP920 IP phones.
Permitted
Values
String within 32 characters
Default Blank
Web UI Features->Forward&DND->Forward->AccountX->No Answer Forward->Target
Phone UI Menu->Features->Call Forward->AccountX->No Answer Forward->Forward to
Parameter
account.X.timeout_fwd.timeout
[1]
<MAC>.cfg
Description
It configures ring times (N) to wait before forwarding incoming calls.
The incoming calls will be forwarded when not answered after N*M (M is configurable by “phone_set-
ting.ring_duration”) seconds.
Note: It works only if “features.fwd.allow” is set to 1 (Enabled) and “features.fwd_mode” is set to 1 (Cus-
tom). It is not applicable to T19(P) E2/CP920 IP phones.
Permitted
Values
Integer from 0 to 20 (determined by “features.forward.no_answer.show_ring_times”)
Default 2
Web UI Features->Forward&DND->Forward->AccountX->No Answer Forward->After Ring Time(0~120s)
Phone UI Menu->Features->Call Forward->AccountX->No Answer Forward->After Ring Time
Parameter
account.X.timeout_fwd.on_code
[1]
<MAC>.cfg
Description
It configures the no answer forward on code to activate the server-side no answer forward feature.
The IP phone will send the no answer forward on code and the pre-configured destination number (con-
figured by the parameter “account.X.timeout_fwd.target”) to the server when you activate no answer for-
ward feature on the IP phone.
Note: It works only if “features.fwd.allow” is set to 1 (Enabled) and “features.fwd_mode” is set to 1 (Cus-
tom). It is not applicable to T19(P) E2/CP920 IP phones。
Permitted
Values
String within 32 characters
To Next Page
Loading...
