Yealink T21PE2 - Page 497

Configuration Parameters
491
Values 1-Enabled
Default 1
Parameter bw.virtual_user.1.enable <MAC>.cfg
Description
It enables or disables the virtual account for the call center.
Note: It works only if “bw.xsi.enable” is set to 1 (Enabled). It is not applicable to
T48G/T46G/T42G/T41P/T29G IP phones.
Permitted
Values
0-Disabled
1-Enabled
Default 0
Parameter bw.virtual_user.1.label <MAC>.cfg
Description
It configures the virtual account label displayed on the phone.
Note: If you leave it blank, the virtual user name uses VirtualUser1 by default. It is not applicable to
T48G/T46G/T42G/T41P/T29G IP phones.
Permitted
Values
String within 99 characters
Default Blank
Parameter bw.virtual_user.1.xsi.dnd.enable <MAC>.cfg
Description
It enables or disables the user to control the DND status for the virtual account.
Note: It works only if “bw.xsi.enable” and “bw.virtual_user.1.enable” are set to 1 (Enabled). It is not applic-
able to T48G/T46G/T42G/T41P/T29G IP phones.
Permitted
Values
0-Disabled
1-Enabled
Default 0
Parameter bw.virtual_user.1.xsi.user <MAC>.cfg
Description
It configures the user ID of virtual account for XSI access authentication.
Note: It works only if “bw.xsi.enable” is set to 1 (Enabled). It is not applicable to
T48G/T46G/T42G/T41P/T29G IP phones.
Permitted
Values
String within 99 characters
Default Blank
Parameter bw.virtual_user.1.xsi.password <MAC>.cfg
Description
It configures the password of virtual account for XSI access authentication.
Note: It works only if “bw.xsi.enable” is set to 1 (Enabled) and it is required only when the value of the
parameter “sip.authentication_for_xsi” is set to 0 (User Login Credentials for XSI Authentication). It is not
applicable to T48G/T46G/T42G/T41P/T29G IP phones.
Permitted
Values
String within 99 characters
Default Blank