Yealink W53P

Account Settings
97
If it is set to 0 when UDP is used ("account.X.sip_server.Y.transport_type" is set to 0), the phone uses
a random port for responsing the messages from server.
Example:
account.1.sip_server.1.port = 5060
Permitted Val-
ues
Integer from 0 to 65535
Default 5060
Web UI Account->Register->SIP Server Y->Port
Handset UI OK->Settings->Telephony->Server (default PIN: 0000) ->Server Y (Account X) ->Port
Parameter
account.X.outbound_proxy_enable
[1]
<MAC>.cfg
Description It enables or disables the IP phone to send requests to the outbound proxy server.
Permitted Val-
ues
0-Disabled
1-Enabled
Default 0
Web UI Account->Register->Enable Outbound Proxy Server
Parameter
account.X.outbound_proxy.Y.address
[1][2]
<MAC>.cfg
Description
It configures the IP address or domain name of the outbound proxy server Y.
Example:
account.1.outbound_proxy.1.address = 10.1.8.11
Note: It works only if “account.X.outbound_proxy_enable” is set to 1 (Enabled).
Permitted Val-
ues
IP address or domain name
Default Blank
Web UI Account->Register->Outbound Proxy Server Y
Parameter
account.X.outbound_proxy.Y.port
[1][2]
<MAC>.cfg
Description
It configures the port of the outbound proxy server Y.
Example:
account.1.outbound_proxy.1.port = 5060
Note: It works only if “account.X.outbound_proxy_enable” is set to 1 (Enabled).
Permitted Val-
ues
Integer from 0 to 65535
Default 5060
Web UI Account->Register->Outbound Proxy Server Y->Port
Handset UI
OK->Settings->Telephony->Server (default PIN: 0000) ->Outbound Proxy (Account X) ->Port (only
applicable to port 1)
Parameter
account.X.reg_fail_retry_interval
[1]
<MAC>.cfg
Description
It configures the interval (in seconds) at which the IP phone to retries to re-register account X when
registration fails.