Yealink W53P - Ipv4 Configuration

Administrator’s Guide for W60P/W53P/W41P DECT Phones
16
Handset UI OK->Settings->System Settings->Network (default PIN: 0000) ->Basic->IP Mode
DD Phone
UI
Menu->Settings->Advanced Settings (default password: 0000)->Network->WAN Port->IP Mode
[1]
If you change this parameter, the IP phone will reboot to make the change take effect.
IPv4 Configuration
The following table lists the parameters you can use to configure IPv4.
Parameter
static.network.internet_port.type
[1]
<y0000000000xx>.cfg
Description
It configures the Internet port type for IPv4.
Note: It works only if “static.network.ip_address_mode” is set to 0 (IPv4) or 2 (IPv4 & IPv6).
Permitted
Values
0-DHCP
2-Static IP Address
Default 0
Web UI Network->Basic->IPv4 Config
Handset UI OK->Settings->System Settings->Network (default PIN: 0000) ->Basic->IPv4->IP Address Type
DD Phone
UI
Menu->Settings->Advanced Settings (default password: 0000)->Network->WAN Port->IPv4
Parameter
static.network.internet_port.ip
[1]
<y0000000000xx>.cfg
Description
It configures the IPv4 address.
Example:
static.network.internet_port.ip = 192.168.1.20
Note: It works only if “static.network.ip_address_mode” is set to 0 (IPv4) or 2 (IPv4 & IPv6), and "stat-
ic.network.internet_port.type" is set to 2 (Static IP Address).
Permitted
Values
IPv4 Address
Default Blank
Web UI Network->Basic->IPv4 Config->Static IP Address->IP Address
Handset UI
OK->Settings->System Settings->Network (default PIN: 0000) ->Basic->IPv4->IP Address Type: Static-
>IP Address
DD Phone
UI
Menu->Settings->Advanced Settings (default password: 0000)->Network->WAN Port->IPv4->Static IPv4
Client->IP Address
Parameter
static.network.internet_port.mask
[1]
<y0000000000xx>.cfg
Description
It configures the IPv4 subnet mask.
Example:
static.network.internet_port.mask = 255.255.255.0
Note: It works only if “static.network.ip_address_mode” is set to 0 (IPv4) or 2 (IPv4 & IPv6), and "stat-
ic.network.internet_port.type" is set to 2 (Static IP Address).
Permitted
Subnet Mask