Yealink W53P

Administrator’s Guide for W60P/W53P/W41P DECT Phones
92
Default 1
Web UI Settings->Call Display->Display Called Party Information
Parameter phone_setting.call_info_display_method <y0000000000xx>.cfg
Description
It configures the call information display method when the IP phone receives an incoming call, dials an
outgoing call or is during an active call.
Permitted
Values
0-Name+Number
1-Number+Name
2-Name
3-Number
4-Full Contact Info (display name<sip:xxx@domain.com>)
Default 0
Web UI Settings->Call Display->Call Information Display Method
Parameter
account.X.update_ack_while_dialing
[1]
<MAC>.cfg
Description It enables or disables the IP phone to update the display of call ID according to the ACK message.
Permitted
Values
0-Disabled
1-Enabled
Default 0
Parameter
sip.disp_incall_to_info
[2]
<y0000000000xx>.cfg
Description
It enables or disables the phone to display the identity contained in the To field of the INVITE message
when it receives an incoming call.
Permitted
Values
0-Disabled
1-Enabled
Default 0
[2]
If you change this parameter, the IP phone will reboot to make the change take effect.
Display Method on Dialing
When the IP phone is on the pre-dialing or dialing screen, the account information will be displayed on the LCD
screen.
Yealink IP phones support three display methods: Label, Display Name and User Name. You can customize the account
information to be displayed on the IP phone as required.
Topic
Display Method on Dialing Configuration
Display Method on Dialing Configuration
The following table lists the parameters you can use to configure display method on dialing.
Parameter features.caller_name_type_on_dialing <y0000000000xx>.cfg