Yealink W53P

Phone Provisioning
59
Default 1
Web UI Settings->Auto Provision->DHCP Active
Parameter
static.auto_provision.dhcp_option.list_user_
options
<y0000000000xx>.cfg
Description
It configures the IPv4 custom DHCP option for requesting provisioning server address.
Multiple options are separated by commas.
Note: It works only if “static.auto_provision.dhcp_option.enable” is set to 1 (On).
Permitted Val-
ues
Integer from 128 to 254
Default Blank
Web UI Settings->Auto Provision->IPv4 Custom Option(128~254)
Parameter static.auto_provision.url_wildcard.pn <y0000000000xx>.cfg
Description
It configures the characters to replace the wildcard $PN in the received URL of the provisioning
server.
Note: The configured characters must be in accordance with the actual directory name of the pro-
visioning server.
Permitted Val-
ues
String within 32 characters
Default W60B
Static Provision Configuration
To use the static provision method, you need to obtain the provisioning server address first when configuring a pro-
visioning server.
The provisioning server address can be IP address, domain name or URL. If a user name and password are specified as
part of the provisioning server address, for example, http://user:pwd@server/dir, they will be used only if the server
supports them.
Note
A URL should contain forward slashes instead of back slashes and should not contain spaces. Escape characters are not sup-
ported.
If a user name and password are not specified as part of the provisioning server address, the User Name and Password
of the provisioning server configured on the phone will be used.
The following table lists the parameters you can use to configure static provision.
Parameter static.auto_provision.server.url <y0000000000xx>.cfg
Description It configures the access URL of the provisioning server.
Permitted Values URL within 511 characters
Default Blank
Web UI Settings->Auto Provision->Server URL
Parameter static.auto_provision.server.username <y0000000000xx>.cfg