Yealink W53P

Administrator’s Guide for W60P/W53P/W41P DECT Phones
184
Description
It configures the IP address of the central report collector that accepts voice quality reports contained
in SIP PUBLISH messages.
Permitted Val-
ues
IPv4 Address
Default Blank
Web UI Account->Advanced->VQ RTCP-XR Collector Address
Parameter
account.X.vq_rtcpxr.collector_server_port
[1]
<MAC>.cfg
Description
It configures the port of the central report collector that accepts voice quality reports contained in SIP
PUBLISH messages.
Permitted Val-
ues
Integer from 1 to 65535
Default 5060
Web UI Account->Advanced->VQ RTCP-XR Collector Port
[1]
X is the account ID. X=1-8.
Advisory Tones
Advisory tones are the acoustic signals of your handset, which inform you of different actions and states.
You can configure the following advisory tones independently of each other:
l Keypad Tone: plays when you press any key of the keypad.
l Confirmation: plays when you save settings or place the handset in the charger cradle.
l Low Battery: plays when battery capacity is low and the handset requires charging.
Topic
Advisory Tones Configuration
Advisory Tones Configuration
The following table lists the parameters you can use to configure the advisory tones.
Parameter custom.handset.keypad_tone.enable <y0000000000xx>.cfg
Description
It enables or disables the handset to play a tone when any key is pressed.
Note: It will take effect on all handsets that are registered on the same base station. It works only if “stat-
ic.auto_provision.handset_configured.enable” is set to 1 (Enabled) and the silent mode is off. It is not
applicable to DD phones.
Permitted
Values
0-Disabled
1-Enabled
Default 1
Handset UI OK->Settings->Audio->Advisory Tones->Keypad Tone
Parameter custom.handset.confirmation_tone.enable <y0000000000xx>.cfg
Description
It enables or disables the handset to play a tone when a user saves settings or places the handset in the
charger cradle.