Yealink W53P

General Features
217
Description It enables or disables the session timer.
Permitted
Values
0-Disabled
1-Enabled, the IP phone will send periodic UPDATE requests to refresh the session during a call.
Default 0
Web UI Account->Advanced->Session Timer
Parameter
account.X.session_timer.expires
[1]
<MAC>.cfg
Description
It configures the interval (in seconds) for refreshing the SIP session during a call. For example, an UPDATE
will be sent after 50% of its value has elapsed.
If it is set to 1800 (1800s), the IP phone will refresh the session during a call before 900 seconds.
Example:
account.1.session_timer.expires = 1800
Note: It works only if “account.X.session_timer.enable” is set to 1 (Enabled).
Permitted
Values
Integer from 90 to 7200
Default 1800
Web UI Account->Advanced->Session Expires(90~7200s)
Parameter
account.X.session_timer.refresher
[1]
<MAC>.cfg
Description
It configures the function of the endpoint who initiates the SIP request.
Note: It works only if “account.X.session_timer.enable” is set to 1 (Enabled).
Permitted
Values
0-UAC
1-UAS
Default 0
Web UI Account->Advanced->Session Refresher
[1]
X is the account ID. X=1-8.
Reboot in Talking
Reboot in talking feature allows IP phones to reboot during an active call when it receives a reboot Notify message.
Topic
Reboot in Talking Configuration
Reboot in Talking Configuration
The following table lists the parameters you can use to configure reboot in talking.
Parameter features.reboot_in_talk_enable <y0000000000xx>.cfg
Description It enables or disables the phone to reboot during a call when it receives a reboot Notify message.
Permitted Values
0-Disabled
1-Enabled