Yealink W53P

Troubleshooting Methods
245
From: sip:sipsak@<srchost>
CSeq: 10 NOTIFY
Call-ID: 1234@<srchost>
Event: check-sync;reboot=true
Topic
Notify Reboot Configuration
Notify Reboot Configuration
The following table lists the parameter you can use to configure notify reboot.
Parameter sip.notify_reboot_enable <y0000000000xx>.cfg
Description
It configures the IP phone behavior when receiving a SIP NOTIFY message which contains the header
“Event: check-sync”.
Permitted Val-
ues
0-The IP phone will reboot only if the SIP NOTIFY message contains an additional string “reboot=true”.
1-The IP phone will reboot.
2-The IP phone will ignore the SIP NOTIFY message.
Default 1
Rebooting the IP Phone via Handset User Interface
You can reboot your IP phone via handset user interface.
Procedure
1. Press OK->Settings->System Settings->Base Restart (default PIN: 0000).
2. Press the Done to reboot the phone.
The phone begins rebooting. Any reboot of the phone may take a few minutes.
Rebooting the IP Phone via Web User Interface
You can reboot your IP phone via web user interface.
Procedure
1. Click Settings->Upgrade.
2. Click Reboot to reboot the IP phone.
The phone begins rebooting. Any reboot of the phone may take a few minutes.