Yealink W53P

Phone Provisioning
55
Note: It works only if “static.auto_provision.flexible.enable” is set to 1 (On).
Permitted
Values
Time from 00:00 to 23:59
Default 02:00
Web UI Settings->Auto Provision->Flexible Time
Parameter static.auto_provision.flexible.end_time <y0000000000xx>.cfg
Description
It configures the ending time of the day for the IP phone to perform auto provisioning at random.
If it is left blank or set to a specific value equal to starting time configured by the parameter “static.auto_
provision.weekly.begin_time”, the IP phone will perform auto provisioning at the starting time.
If it is set to a specific value greater than starting time configured by the parameter “static.auto_pro-
vision.weekly.begin_time”, the IP phone will perform auto provisioning at random between the starting
time and ending time.
If it is set to a specific value less than starting time configured by the parameter “static.auto_pro-
vision.weekly.begin_time”, the IP phone will perform auto provisioning at random between the starting
time on that day and ending time in the next day.
Note: It works only if “static.auto_provision.flexible.enable” is set to 1 (On).
Permitted
Values
Time from 00:00 to 23:59
Default Blank
Web UI Settings->Auto Provision->Flexible Time
[1]
If you change this parameter, the IP phone will reboot to make the change take effect.
User-Triggered Provisioning Settings Configuration
You can enable the users to trigger IP phones to perform provisioning by dialing an activation code. This method
works only if there is no registered account on the IP phone.
The following table lists the parameters you can use to configure settings for user-triggered provisioning.
Parameter
static.autoprovision.X.name
[1][2]
<y0000000000xx>.cfg
Description It configures the code name to trigger auto provisioning.
Permitted
Values
String within 64 characters
Default Blank
Parameter
static.autoprovision.X.code
[1][2]
<y0000000000xx>.cfg
Description
It configures the activation code to trigger auto provisioning.
The activation code can be numeric characters, special characters # * or a combination of them.
Example:
static.autoprovision.1.code = 123
static.autoprovision.2.code = **
static.autoprovision.3.code = *123