Administrator’s Guide for W60P/W53P/W41P DECT Phones
238
21-Local Use 5 (Local5)
22-Local Use 6 (Local6)
23-Local Use 7 (Local7)
Note: Note 1 - Various operating systems have been found to utilize Facilities 4, 10, 13 and 14 for secur-
ity/authorization, audit, and alert messages which seem to be similar. Note 2 - Various operating systems
have been found to utilize both Facilities 9 and 15 for clock (cron/at) messages.
Default 16
Web UI Settings->Configuration->Syslog->Syslog Facility
Parameter static.syslog.prepend_mac_address.enable <y0000000000xx>.cfg
Description
It enables or disables the IP phone to prepend the MAC address to the log messages exported to the sys-
log server.
Permitted
Values
0-Disabled
1-Enabled
Default 0
Web UI Settings->Configuration->Syslog->Syslog Prepend MAC
Viewing the Syslog Messages on Your Syslog Server
You can view the syslog file in the desired folder on the syslog server. The location of the folder may differ from the sys-
log server. For more information, refer to the network resources.
The following figure shows a portion of the syslog:
Resetting Phone and Configuration
Generally, some common issues may occur while using the IP phone. You can reset your phone to factory con-
figurations after you have tried all troubleshooting suggestions, but still do not solve the problem. Resetting the phone
to factory configurations clears the flash parameters, removes log files, user data, and cached data, and resets the
administrator password to admin. All custom settings will be overwritten after resetting.
Five ways to reset the phone:
l Reset local settings: All configurations saved in the <MAC>-local.cfg file on the IP phone will be reset. Changes
associated with non-static settings made via web user interface and phone user interface are saved in the <MAC>-
local.cfg file.
To Next Page
Loading...
