Yealink W53P

Administrator’s Guide for W60P/W53P/W41P DECT Phones
136
Replace Rule Configuration
You can configure replace rules either one by one or in batch using a replace rule template.
The following table lists the parameters you can use to configure replace rule.
Parameter
dialplan.replace.prefix.X
[1]
<y0000000000xx>.cfg
Description
It configures the entered number to be replaced.
Example:
dialplan.replace.prefix.1 =1
Permitted
Values
String within 32 characters
Default Blank
Web UI Settings->Dial Plan->Replace Rule->Prefix
Parameter
dialplan.replace.replace.X
[1]
<y0000000000xx>.cfg
Description
It configures the alternate number to replace the entered number.
Example:
dialplan.replace.prefix.1 = 1 and dialplan.replace.replace.1 = 254245
When you enter the number ”1” and press the send key, the number “254245” will replace the entered
number “1”.
Permitted
Values
String within 32 characters
Default Blank
Web UI Settings->Dial Plan->Replace Rule->Replace
Parameter
dialplan.replace.line_id.X
[1]
<y0000000000xx>.cfg
Description
It configures the desired line to apply the replace rule. The digit 0 stands for all lines. If it is left blank, the
replace rule will apply to all lines on the IP phone.
Note: Multiple line IDs are separated by commas.
Permitted
Values
0 to 8
Default Blank
Web UI Settings->Dial Plan->Replace Rule->Account
Parameter dialplan_replace_rule.url <y0000000000xx>.cfg
Description
It configures the access URL of the replace rule template file.
For customizing replace rule template file, refer to Replace Rule File Customization.
Permitted
Values
URL within 511 characters
Default Blank
[1]
X is from 1 to 100.