Yealink W53P

Administrator’s Guide for W60P/W53P/W41P DECT Phones
158
Web UI Features->Transfer->Blind Transfer On Hook
Parameter transfer.on_hook_trans_enable <y0000000000xx>.cfg
Description
It enables or disables the IP phone to complete the semi-attended/attended transfer through on-hook
besides pressing the TRAN key.
Note: Semi-attended transfer means transferring a call after hearing the ringback tone; Attended transfer
means transferring a call with prior consulting.
Permitted
Values
0-Disabled
1-Enabled
Default 1
Web UI Features->Transfer->Attended Transfer On Hook
[1]
X is the account ID. X=1-8.
Conference
The Yealink IP phones support three-way local conference and multi-way network conference.
Topics
Conference Type Configuration
Network Conference Configuration
Conference Type Configuration
You can specify which type of conference to establish.
The following table lists the parameter you can use to set a conference type.
Parameter
account.X.conf_type
[1]
<MAC>.cfg
Description It configures the conference type for a specific account.
Permitted Values
0-Local Conference, the conference is set up with other two parties via the IP phone.
2-Network Conference, the conference is set up with multiple parties via the server.
Default 0
Web UI Account->Advanced->Conference Type
[1]
X is the account ID. X=1-8.
Network Conference Configuration
Network conference, also known as a centralized conference, provides you with the flexibility of call with multiple par-
ticipants (more than three). The IP phones implement network conference using the REFER method specified in RFC
4579. This feature depends on the support from a SIP server
For network conference, if any party leaves the conference, the remaining parties are still connected.
The following table lists the parameter you can use to configure network conference.
Parameter
account.X.conf_uri
[1]
<MAC>.cfg
Description It configures the network conference URI for a specific account.