Yealink W53P

Phone Network
25
Description It enables or disables the CDP (Cisco Discovery Protocol) feature on the IP phone.
Permitted Val-
ues
0-Disabled
1-Enabled, the IP phone will attempt to determine its VLAN ID through CDP.
Default 1
Web UI Network->Advanced->CDP->Active
Parameter
static.network.cdp.packet_interval
[1]
<y0000000000xx>.cfg
Description
It configures the interval (in seconds) at which the IP phone sends the CDP (Cisco Discovery Protocol)
request.
Note: It works only if “static.network.cdp.enable” is set to 1 (Enabled).
Permitted Val-
ues
Integer from 1 to 3600
Default 60
Web UI Network->Advanced->CDP->Packet Interval (1~3600s)
Manual VLAN Configuration
VLAN is disabled on IP phones by default. You can configure VLAN for the Internet port and PC port manually. Before
configuring VLAN on the IP phone, you need to obtain the VLAN ID from your network administrator.
The following table lists the parameters you can use to configure VLAN manually.
Parameter
static.network.vlan.internet_port_enable
[1]
<y0000000000xx>.cfg
Description It enables or disables the VLAN for the Internet port.
Permitted Val-
ues
0-Disabled
1-Enabled
Default 0
Web UI Network->Advanced->VLAN->WAN Port->Active
Handset UI OK->Settings->System Settings->Network (default PIN: 0000) ->VLAN->VLAN Parameter->Status
DD Phone UI
Menu->Settings->Advanced Settings (default password: 0000) ->Network->VLAN->WAN Port-
>VLAN Status
Parameter
static.network.vlan.internet_port_vid
[1]
<y0000000000xx>.cfg
Description
It configures the VLAN ID for the Internet port.
Note: It works only if “static.network.vlan.internet_port_enable” is set to 1 (Enabled).
Permitted Val-
ues
Integer from 1 to 4094
Default 1
Web UI Network->Advanced->VLAN->WAN Port->VID (1-4094)
Handset UI
OK->Settings->System Settings->Network (default PIN: 0000) ->VLAN->VLAN Parameter->Status:
Enabled->VID
DD Phone UI
Menu->Settings->Advanced Settings (default password: admin) ->Network->VLAN->WAN Port-
>VID Number
Parameter
static.network.vlan.internet_port_priority
[1]
<y0000000000xx>.cfg