Yealink W53P

Handset Customization
71
Permitted Val-
ues
0-Disabled (handset power indicator LED is off)
1-Enabled (handset power indicator LED fast flashes (300ms) red)
Default 1
Web UI Features->Power LED->Ringing Power Light Flash
Parameter phone_setting.mail_power_led_flash_enable <y0000000000xx>.cfg
Description
It enables or disables the handset power indicator LED to flash when the handset receives a voice
mail.
Permitted Val-
ues
0-Disabled (handset power indicator LED does not flash)
1-Enabled (handset power indicator LED slow flashes (1000ms) red)
Default 1
Web UI Features->Power LED->Voice/Text Mail Power Light Flash
Parameter
phone_setting.missed_call_power_led_flash.en-
able
<y0000000000xx>.cfg
Description
It enables or disables the handset power indicator LED to flash when the handset receives an incom-
ing call.
Permitted Val-
ues
0-Disabled (handset power indicator LED does not flash)
1-Enabled (handset power indicator LED slow flashes (1000ms) red)
Default 1
Web UI Features->Power LED->MissCall Power Light Flash
Handset Keypad Light
You can enable the handset keypad light to make the keypad light up when any key is pressed. This helps you dis-
tinguish keys from each other in a dark environment.
Topic
Handset Keypad Light Configuration
Handset Keypad Light Configuration
The following table lists the parameter you can use to configure the handset keypad light.
Parameter custom.handset.keypad_light.enable <y0000000000xx>.cfg
Description
It enables or disables the handset to turn on the keypad light (digital key, # key, * key, TRAN key and
Mute key) when any key is pressed.
Note: It will take effect on all handsets that are registered on the same base station. It works only if “stat-
ic.auto_provision.handset_configured.enable” is set to 1 (Enabled). It is not applicable to DD phones.
Permitted
Values
0-Disabled
1-Enabled
Default 1
Handset UI OK->Settings->Display->Keypad LED