Yealink W53P

Administrator’s Guide for W60P/W53P/W41P DECT Phones
156
DD Phone
UI
Menu->Features->Call Forward->AccountX->No Answer Forward->After Ring Time
Parameter
account.X.timeout_fwd.on_code
[1]
<MAC>.cfg
Description
It configures the no answer forward on code to activate the server-side no answer forward feature.
The IP phone will send the no answer forward on code and the pre-configured destination number (con-
figured by the parameter “account.X.timeout_fwd.target”) to the server when you activate no answer for-
ward feature on the IP phone.
Note: It works only if “features.fwd.allow” is set to 1 (Enabled)。
Permitted
Values
String within 32 characters
Default Blank
Web UI Features->Forward&DND->Forward->AccountX->No Answer Forward->On Code
Parameter
account.X.timeout_fwd.off_code
[1]
<MAC>.cfg
Description
It configures the no answer forward off code to deactivate the server-side no answer forward feature.
The IP phone will send the no answer forward off code to the server when you deactivate no answer for-
ward feature on the IP phone.
Note: It works only if “features.fwd.allow” is set to 1 (Enabled).
Permitted
Values
String within 32 characters
Default Blank
Web UI Features->Forward&DND->Forward->AccountX->No Answer Forward->Off Code
[1]
X is the account ID. X=1-8.
Call Forward Synchronization for Server-side Configuration
Call forward synchronization feature provides the capability to synchronize the status of the call forward features
between the IP phone and the server.
If the call forward is activated in phone mode, the forward status changing locally will be synchronized to all registered
accounts on the server; but if the forward status of the specific account is changed on the server, the forward status
locally will be changed.
The following table lists the parameters you can use to configure call forward synchronization for server-side.
Parameter features.feature_key_sync.enable <y0000000000xx>.cfg
Description It enables or disables to synchronize the feature status between the IP phone and the server.
Permitted Values
0-Disabled
1-Enabled, the IP phone send a SUBSCRIBE message with event “as-feature-event” to the server.
Default 0