Yealink W53P

Administrator’s Guide for W60P/W53P/W41P DECT Phones
26
Description
It configures the VLAN priority for the Internet port.
7 is the highest priority, 0 is the lowest priority.
Note: It works only if “static.network.vlan.internet_port_enable” is set to 1 (Enabled).
Permitted Val-
ues
Integer from 0 to 7
Default 0
Web UI Network->Advanced->VLAN->WAN Port->Priority
Handset UI
OK->Settings->System Settings->Network (default PIN: 0000) ->VLAN->VLAN Parameter->Status:
Enabled->Priority
DD Phone UI
Menu->Settings->Advanced Settings (default password: admin) ->Network->VLAN->WAN Port->Pri-
ority
[1]
If you change this parameter, the IP phone will reboot to make the change take effect.
DHCP VLAN
Yealink IP phones support VLAN discovery via DHCP. When the VLAN discovery method is set to DHCP, the IP phone
will examine DHCP option for a valid VLAN ID. The predefined option 132 is used to supply the VLAN ID by default. You
can customize the DHCP option used to request the VLAN ID.
The following table lists the parameters you can use to configure DHCP VLAN discovery.
Parameter
static.network.vlan.dhcp_enable
[1]
<y0000000000xx>.cfg
Description It enables or disables the DHCP VLAN discovery feature on the IP phone.
Permitted Val-
ues
0-Disabled
1-Enabled
Default 1
Web UI Network->Advanced->VLAN->DHCP VLAN->Active
Handset UI OK->Settings->System Settings->Network (default PIN: 0000) ->VLAN->VLAN DHCP->Status
DD Phone UI
Menu->Settings->Advanced Settings (default password: 0000) ->Network->VLAN->DHCP VLAN-
>DHCP VLAN
Parameter
static.network.vlan.dhcp_option
[1]
<y0000000000xx>.cfg
Description
It configures the DHCP option from which the IP phone will obtain the VLAN settings.
You can configure at most five DHCP options and separate them by commas.
Permitted Val-
ues
Integer from 1 to 255
Default 132
Web UI Network->Advanced->VLAN->DHCP VLAN->Option (1-255)
Handset UI
OK->Settings->System Settings->Network (default PIN: 0000) ->VLAN->VLAN DHCP->Status:
Enabled->Options
DD Phone UI
Menu->Settings->Advanced Settings (default password: 0000) ->Network->VLAN->DHCP VLAN-
>Option
[1]
If you change this parameter, the IP phone will reboot to make the change take effect.