Yealink W53P

Administrator’s Guide for W60P/W53P/W41P DECT Phones
58
Parameter
static.auto_provision.user_agent_mac.enable
[1]
<y0000000000xx>.cfg
Description
It enables or disables the IP phone's MAC address to be included in the User-Agent header of
HTTP/HTTPS transfers via auto provisioning.
Permitted
Values
0-Disabled, the phone’s MAC address is not included in the User-Agent header of HTTP/HTTPS transfers
and communications to the web browser.
1-Enabled
Default 1
[1]
If you change this parameter, the IP phone will reboot to make the change take effect.
Supported Provisioning Server Discovery Methods
After the phone has established network settings, it must discover a provisioning server to obtain software updates and
configuration settings.
The IP phone supports the following methods to discover the provisioning server address:
l PnP: PnP feature allows IP phones to discover the provisioning server address by broadcasting the PnP SUBSCRIBE
message during startup.
l DHCP: DHCP option can be used to provide the address or URL of the provisioning server to IP phones. When the IP
phone requests an IP address using the DHCP protocol, the resulting response may contain option 66 (for IPv4) or
the custom option (if configured) that contains the provisioning server address.
l Static: You can manually configure the server address via handset user interface or web user interface.
Topics
PnP Provision Configuration
DHCP Provision Configuration
Static Provision Configuration
PnP Provision Configuration
The following table lists the parameter you can use to configure PnP provision.
Parameter static.auto_provision.pnp_enable <y0000000000xx>.cfg
Description It triggers the Plug and Play (PnP) feature to on or off.
Permitted Val-
ues
0-Off
1-On, the IP phone will broadcast PnP SUBSCRIBE messages to obtain a provisioning server address
during startup.
Default 1
Web UI Settings->Auto Provision->PNP Active
DHCP Provision Configuration
The following table lists the parameters you can use to configure DHCP provision.
Parameter static.auto_provision.dhcp_option.enable <y0000000000xx>.cfg
Description It triggers the DHCP Active feature to on or off.
Permitted Val-
ues
0-Off
1-On, the IP phone will obtain the provisioning server address by detecting DHCP options.