Yealink W53P

Configuration Parameters
229
[1]
X is the account ID. X=1-8.
[2]
If you change this parameter, the IP phone will reboot to make the change take effect.
Call Settings Parameters
Parameter phone_setting.end_call_net_disconnect.enable <y0000000000xx>.cfg
Description It enables or disables the IP phone to end the call if the network is unavailable during the call.
Permitted Values
0-Disabled
1-Enabled, the IP phone will end the call and go to the Idle screen after 5 seconds.
Default 0
Base Settings Parameters
Parameter
base.eco_mode.enable
[1]
<y0000000000xx>.cfg
Description
It enables or disables the eco mode+ to turn off the transmission power when the phone is in the standby
mode.
Permitted
Values
0-Disabled
1-Enabled, there will be no signal interaction between the handset and the base station, the color of the
signal strength indicator on the idle screen displays in green.
Default 0
Handset UI OK->Settings->System Settings->Eco Mode+
Parameter
static.base.repeater_mode.enable
[1]
<y0000000000xx>.cfg
Description It configures the repeater mode to extend the radio coverage of the base station.
Permitted
Values
0-Disabled
1-RT10, RT20 or RT20U
2-RT30
Default 0
Handset UI OK->Settings->System Settings->Repeater Mode
[1]
If you change this parameter, the IP phone will reboot to make the change take effect.
Handset Settings Parameters
Parameter custom.handset.eco_mode.enable <y0000000000xx>.cfg
Description
It enables or disables the eco mode to greatly reduce the transmission power and signal output when
the phone is in the talk mode.
Note: It is not applicable to DD phones.
Permitted
Values
0-Disabled
1-Enabled
Default 0