Yealink W53P

Administrator’s Guide for W60P/W53P/W41P DECT Phones
166
ues 1-Enabled
Default 1
Web UI Features->General Information->Voice Mail Tone
Ring Tones
Ring tones are used to play for incoming calls.
You can specify a period of time after which the IP phone will stop ringing if the call is not answered.
Topic
Ringtone Configuration
Ringer Device
The IP phones support either or both speaker and headset ringer devices. You can configure which ringer device to be
used when receiving an incoming call. For example, if the ringer device is set to Headset, ring tone will be played
through your headset.
Topic
Ringer Device Configuration
Ringer Device Configuration
The following table lists the parameters you can use to configure ringer device.
Parameter features.ringer_device.is_use_headset <y0000000000xx>.cfg
Description
It configures the ringer device for the IP phone.
Note: It is not applicable to IP phones.
Permitted Values
0-Use Speaker
1-Use Headset
Default 0
Web UI Features->Audio->Ringer Device for Headset
Tones
When receiving a message, the IP phone will play a warning tone. You can customize tones or select specialized tone
sets (vary from country to country) to indicate different conditions of the IP phone.
Topics
Supported Tones
Tones Configuration
Supported Tones
The default tones used on IP phones are the US tone sets. Available tone sets for IP phones: