Yealink W53P

Phone Provisioning
49
can resolve the domain name to the IP address of the IP phone.
Permitted
Values
String
If it is left blank, you are only allowed to use IP address to access the web user interface of the IP phone.
If it is set to “any”, you can use IP address or any domain name to access the web user interface of the IP
phone.
Default any
Web Server Type Configuration
Yealink IP phones support both HTTP and HTTPS protocols for accessing the web user interface. You can configure the
web server type. Web server type determines access protocol of the web user interface. If you disable to access web
user interface using the HTTP/HTTPS protocol, both you and the user cannot access the web user interface.
The following table lists the parameters you can use to configure web server type.
Parameter
static.wui.http_enable
[1]
<y0000000000xx>.cfg
Description
It enables or disables the user to access the web user interface of the IP phone using the HTTP pro-
tocol.
Permitted Val-
ues
0-Disabled
1-Enabled
Default 1
Web UI Network->Advanced->Web Server->HTTP
Parameter
static.network.port.http
[1]
<y0000000000xx>.cfg
Description
It configures the HTTP port for the user to access the web user interface of the IP phone using the
HTTP protocol.
Permitted Val-
ues
Integer from 1 to 65535
Default 80
Web UI Network->Advanced->Web Server->HTTP Port (1~65535)
Parameter
static.wui.https_enable
[1]
<y0000000000xx>.cfg
Description
It enables or disables the user to access the web user interface of the IP phone using the HTTPS pro-
tocol.
Permitted Val-
ues
0-Disabled
1-Enabled
Default 1
Web UI Network->Advanced->Web Server->HTTPS
Parameter
static.network.port.https
[1]
<y0000000000xx>.cfg
Description
It configures the HTTPS port for the user to access the web user interface of the IP phone using the
HTTPS protocol.
Permitted Val-
ues
Integer from 1 to 65535
Default 443
Web UI Network->Advanced->Web Server->HTTPS Port (1~65535)