Yealink W53P

Handset Customization
73
Parameter custom.handset.wallpaper <y0000000000xx>.cfg
Description
It configures the wallpaper displayed on the handset LCD screen.
Note: It will take effect on all handsets that are registered on the same base station. It works only if “stat-
ic.auto_provision.handset_configured.enable” is set to 1 (Enabled). It is not applicable to DD phones.
Permitted
Values
1-Wallpaper1
2-Wallpaper2
3-Wallpaper3
4-Wallpaper4
5-Wallpaper5
Default -1, do not change the wallpaper set on each handset.
Handset UI OK->Settings->Display->Wallpaper
Handset Screen Saver
The screen saver of the handset is designed to protect your LCD screen. You can enable the screen saver to protect the
LCD screen, an analog clock will be activated and appear on the LCD screen after the handset is idle for approximately
10 seconds.
Topic
Handset Screen Saver Configuration
Handset Screen Saver Configuration
The following table lists the parameter you can use to configure the handset screen saver.
Parameter
custom.handset.screen_saver.enable
[1]
<y0000000000xx>.cfg
Description
It enables or disables screen saver feature.
Note: It will take effect on all handsets that are registered on the same base station. It works only if “stat-
ic.auto_provision.handset_configured.enable” is set to 1 (Enabled). It is not applicable to DD phones.
Permitted
Values
0-Disabled
1-Enabled, an analog clock will be activated and appear on the LCD screen if no user activity is sensed for
approximately 10 seconds.
Default 1
Handset UI OK->Settings->Display->Screen Saver
Handset Name
The handset will be assigned a name by default if successfully registered to the base station. You can personalize the
handset name.
Topic
Handset Name Configuration