Yealink W53P

Phone Provisioning
57
Values
Default 5
[1]
X is an activation code ID. For all IP phones, X=1-50.
[2]
If you change this parameter, the IP phone will reboot to make the change take effect.
Setting Up a Provisioning Server
You can use a provisioning server to configure your IP phones. A provisioning server allows for flexibility in upgrading,
maintaining and configuring the phone. Boot files, configuration files and resource files are normally located on this
server.
Topics
Supported Provisioning Protocols
Supported Provisioning Server Discovery Methods
Configuring a Provisioning Server
Supported Provisioning Protocols
Yealink IP phones support several transport protocols for provisioning:
l Trivial File Transfer Protocol (TFTP)
l File Transfer Protocol (FTP)
l Hyper Text Transfer Protocol – Secure (HTTPS)
l File Transfer Protocol – Secure (FTPS)
Note
There are two types of FTP methods—active and passive. IP phones are not compatible with active FTP.
You can specify the transport protocol in the provisioning server address, for example, http://xxxxxxx. If not specified,
the TFTP protocol is used.
Topic
Provisioning Protocols Configuration
Provisioning Protocols Configuration
The following table lists the parameters you can use to configure provisioning protocols.
Parameter static.auto_provision.server.type <y0000000000xx>.cfg
Description
It configures the protocol the IP phone uses to connect to the provisioning server.
Note: It works only if the protocol type is not defined in the access URL of the provisioning server con-
figured by the parameter "static.auto_provision.server.url".
Permitted
Values
1-HTTP
2-HTTPS
3-FTP
Other values-TFTP
Default TFTP