Yealink W53P

Handset Customization
75
Phone User Interface Web User Interface
French / French 4.French.js 4.French_note.xml
German / German 5.German.js 5.German_note.xml
Italian / Italian 6.Italian.js 6.Italian_note.xml
Polish / Polish 7.Polish.js 7.Polish_note.xml
Portuguese / Portuguese 8.Portuguese.js 8.Portuguese_note.xml
Spanish / Spanish 9.Spanish.js 9.Spanish_note.xml
Turkish / Turkish 10.Turkish.js 10.Turkish_note.xml
Russian / Russian 11.Russian.js 11.Russian_note.xml
Language Display Configuration
The default language displayed on the phone/handset user interface is English. If your web browser displays a lan-
guage not supported by the IP phone, the web user interface will display English by default. You can specify the lan-
guages for the phone/handset user interface and web user interface respectively.
The following table lists the parameters you can use to configure language display.
Parameter lang.wui <y0000000000xx>.cfg
Description It configures the language used on the web user interface.
Permitted
Values
English, French, German, Italian, Polish, Portuguese, Spanish, Turkish, Russian or the custom language
name.
Default English
Web UI On the top-right corner of the web user interface
Parameter custom.handset.language <y0000000000xx>.cfg
Description
It configures the language used on the handset user interface.
Note: It will take effect on all handsets that are registered on the same base station. It works only if “stat-
ic.auto_provision.handset_configured.enable” is set to 1 (Enabled). It is not applicable to DD phones.
Permitted
Values
0-English
1-French
2-German
3-Italian
4-Polish
5-Portuguese
6-Spanish
7-Turkish
8-Swedish