Yealink W53P

Administrator’s Guide for W60P/W53P/W41P DECT Phones
168
Example:
voice.tone.country = Custom
Permitted
Values
Custom, Australia, Austria, Brazil, Belgium, Chile, China, Czech, Czech ETSI, Denmark, Finland, France, Ger-
many, Great Britain, Greece, Hungary, Lithuania, India, Italy, Japan, Mexico, New Zealand, Netherlands,
Norway, Portugal, Spain, Switzerland, Sweden, Russia, United States
Default Custom
Web UI Settings->Tones->Select Country
Parameter voice.tone.dial <y0000000000xx>.cfg
Description
It customizes the dial tone.
tone list = element[,element] [,element]…
Where
element = [!]Freq1[+Freq2][+Freq3][+Freq4] /Duration
Freq: the frequency of the tone (ranges from 200 to 4000 Hz). If it is set to 0 Hz, it means the tone is not
played.
Duration: the duration (in milliseconds) of the dial tone, ranges from 0 to 30000ms.
You can configure at most eight different tones for one condition, and separate them by commas. (for
example, 250/200,0/1000,200+300/500,200+500+800+1500/1000).
If you want the IP phone to play tones once, add an exclamation mark “!” before tones (for example,
!250/200,0/1000, 200+300/500,200+500+800+1500/1000).
Note: It works only if “voice.tone.country” is set to Custom.
Permitted
Values
String
Default Blank
Web UI Settings->Tones->Dial
Parameter voice.tone.ring <y0000000000xx>.cfg
Description
It customizes the ringback tone.
The value format is Freq/Duration. For more information on the value format, refer to the parameter
“voice.tone.dial”.
Note: It works only if “voice.tone.country” is set to Custom. If you want to disable this warning tone, set
it to 0.
Permitted
Values
String
Default Blank
Web UI Settings->Tones->Ring Back
Parameter voice.tone.busy <y0000000000xx>.cfg
Description
It customizes the tone when the callee is busy.
The value format is Freq/Duration. For more information on the value format, refer to the parameter
“voice.tone.dial”.